Most of the time, companies will spend lots of money to purchase their forklifts. It is essential, therefore to take good care of your machine to protect your investment into the long run. It is really a great idea to know the procedures which are undertaken in maintaining and taking care of this machinery.
By starting up the forklift and listening carefully how it works is one of the best ways to tell how good the engine is performing. Like for example, if there are any misses or knocks, the equipment is faulty and this must raise some issues. Also listen closely for any squealing sounds that come from the belts because these sounds would provide you with a lot of information.
Some of the main parts requiring attention during maintenance comprise the horn, safety warning devices, gauges, the lights and the overhead guard. Any burnt out light bulbs or faulty components must be replaced as soon as they are noticed. It is also essential to inspect the wiring.
The battery compartment terminals should be cleaned when the above parts have been inspected thoroughly. If the terminals are not clean, be sure to clean them properly. Every battery cell must be inspected in order to ensure the fill level is topped up to the regulated amount.
An oil change is the next step to drain all the oil out of the machine and then change the filters. The transmission filter, fuel filters and the hydraulic filter should be frequently replaced. Before fitting them, be sure to write the date on the new filters by utilizing a permanent marker in order to keep track.
When the oil change is finished and the filters have been replaced, a visual inspection of the drive axle needs to be carried out. If there is a grease fitting on the axle make sure to apply some grease. Check the belts on the engine for any frays or cracks. If you find any, fix the issue accordingly. After that, inspect each and every other component of the machine including the wheels. If any type of fault or concern is detected, be certain to address it immediately in order to make sure the equipment is working at its safest and optimum levels.